The circuit below illuminates an LED to indicate unequal charges between
two 12 volt lead batteries. It can be used to verify that two batteries
are connected in parallel or isolated since the LED will be off when
the voltages are equal within a tollerance, or on if the voltage
difference is greater than 100 millivolts. Three comparators and three
voltage dividers are used to determine battery conditions.
Battery Equal Charge Indicator Circuit Diagram
Battery Equal Charge Indicator Circuit Diagram
The upper left comparator (+) input at pin 5 is set to about 10 volts
with battery #1 at 12 volts. The negative input (pin 4) is set to a
slightly lower voltage by adding an additional 240 ohms to the voltage
divider so that the output of the comparator will be positive when both
battery voltages are equal and negative if battery 2 rises above battery
1 by 100 millivolts or more.
The voltage at pin 5 is used as a reference for the lower comparator and the negative input of the lower comparator is set to a lower voltage with the addition of 510 ohms, so that the output will also be positive when the battery voltages are equal and negative when battery #1 is greater than #2 by 100 millivolts or more.
The two comparator outputs are both connected to the positive input of the third comparator at pin 9 so that the LED will illuminate when either condition exists,
(Battery #1 > Battery #2) OR (Battery #2 > Battery #1).
The voltage at pin 5 is used as a reference for the lower comparator and the negative input of the lower comparator is set to a lower voltage with the addition of 510 ohms, so that the output will also be positive when the battery voltages are equal and negative when battery #1 is greater than #2 by 100 millivolts or more.
The two comparator outputs are both connected to the positive input of the third comparator at pin 9 so that the LED will illuminate when either condition exists,
(Battery #1 > Battery #2) OR (Battery #2 > Battery #1).
0 comments:
Post a Comment