A low-cost circuit of an FM booster that can be used to listen programs
from distant FM stations clearly. The circuit comprises a common-emitter
tuned RF preamplifier wired around VHF/UHF transistor 2SC2570 ( C2570).
this FM booster circuit is constructed using few common components( not
require some special components ) and provide a very good gain .to
calibrate this circuit you need to adjust input/output trimmers
(VC1/VC2) for maximum gain.
FM Booster Circuit Diagram Circuit Diagram
Input coil L1 consists of four turns of 20SWG enamelled copper wire
(slightly space wound) over 5mm diameter former. It is tapped at the
first turn from ground lead side. Coil L2 is similar to L1, but has only
three turns. Both of the trimmers are 22pF value. This FM radio signal
booster needs to be powered by a 12 volts DC power supply .
0 comments:
Post a Comment