This power supply is powered by a transformer operating from 120 Vac on the
primary and providing proximately 20 Vac on the primary, and providing
approximately 20 Vac on the secondary. Four 10-A diodes with a 100 PIV
rating are used in a full-wave bridge rectifier.
8-Amp Regulated Power Supply Circuit Diagram
A 10,000 ^F/36 Vdc capacitor completes the filtering, providing 28 Vdc.
The dc voltage is fed to the collectors of the Darlington connected
2N3055's. Base drive for the pass transistors is from pin 10 of the µ723
through a 200 ohm current limiting resistor, Rl. The reference terminal
(pin 6) is tied directly to the non-inverting input of the error
amplifier (pin 5), providing 7.15 V for comparison.
The inverting input to the error amplifier (pin 4) is fed from the center arm of a 10 k ohm potentiometer connected across the output of the supply. This control is set for the desired output voltage of 13.8 V. Compensation of the error amplifier is accomplished with a 500 pF capacitor connected from pin 13 to pin 4. If the power supply should exceed 8 A or develop a short circuit, the µ723 regulator will bias the transistors to cutoff and the output voltage will drop to near zero until the short circuit condition is corrected.
The inverting input to the error amplifier (pin 4) is fed from the center arm of a 10 k ohm potentiometer connected across the output of the supply. This control is set for the desired output voltage of 13.8 V. Compensation of the error amplifier is accomplished with a 500 pF capacitor connected from pin 13 to pin 4. If the power supply should exceed 8 A or develop a short circuit, the µ723 regulator will bias the transistors to cutoff and the output voltage will drop to near zero until the short circuit condition is corrected.
0 comments:
Post a Comment